Not sure if it's the right place for this question.
I'm using a MSX2+ with audio video cables and in certain modes it looks good, while in others (with higher resolutions) the pixels have like a shadow, so with small letters it's complicated even to read.
Now I've noticed that with certain games (like Bubble Bobble) the image becomes black and white and it loses pixels. Why could that happen, and especially, how could I fix it?
Composite video, not RGB, is very low image quality, as signals from video chip modulated and mixed into 1 single signal. That is the reason why you can see pixels flickering or with shadows or color spill.
If you are getting black and white in some modes, maybe it is because of bad modulator and/or bad cable or a not-so-compatible monitor.
Try 50 hz and 60 hz to test.
A good try is to check (and maybe replace) capacitors or other components in the modulator board.
No, it would not. V9990 is not a replacement for the V9958 in your MSX2+, but an addition. So, using screen 6 or 7 (or screen 0 with width 80) would still use the build-in video display processor.
Use a RGB / SCART connection. Composite video picture quality is horrendous.
European TVs will have a SCART input so all you need is the right cable. For TVs outside of Europe you’ll need to get a SCART to HDMI converter as well, these aren’t terribly expensive (€10-€30) and offer adequate results (the EU TVs essentially have this built in).
For the best image quality you want a more expensive SCART to HDMI converter such as the OSSC or the FrameMeister. These will give you really sharp pixels, nice colours and no deinterlacing artifacts, and the OSSC also introduces zero latency. But they’re not cheap, upwards of €200.
On a flat screen composite is really not an option. a small crt screen could be "acceptable". RGB is really the only output you should pay attention to.
There are several rgb (scart) to hdmi converters, but not all of them are as good a you might hope. I use some of these in case I need to use a scartless flatscreen: Available for several prices in several shops..
The screen to the left is sending the RGB from a Sony HB-F1XDJ to a IIyama LCD monitor's HDMI inlet. I think it is very acceptable.
